What moves your vehicle? Wheels, engine, or the fuel! All of them does, but they all are void without a gear shift cable. Almost all vehicles, be they cars or bikes, make use of connection of gear shift handle and shifting cable for transmission to move. Cars with the automatic transmission typically use a single shifting cable while vehicles with manual transmission make use of two shifter cables. While the installation part may be a bit different, the job of the shifter cable in both kinds of vehicles is same.
You are not supposed to blame the faulty transmission if you get stuck in the middle with your car, the reason may sometimes be the broken shifter cable. Though moving the shifter handle to shift the gear is easy but, it may sometimes be too easy to move the shift handle into any direction. Those, who are wise may have got the clue. This is actually the symptom which indicates that the shifter cable has gone out of order. You need to seek now gear shift cable replacement at this point. Despite moving the gear handle, your car may stay neutral or may get stuck in the same gear as it was at the time of gear cable breakage. So, what to do now? Either you can replace the cable yourself, or you can get it fixed by a mechanic.
You know the reason very well why and how the gear shift cable gets broken. Reasons are many, but the excessive pressure and tension is the primary one. Besides, overheating in the transmission may also cause breakage of the cable. Replacing the gear shift cable is neither a problematic job nor a costly affair. This is a kind of DIY process.
Here are some resourceful tips that can help you with the gear shift cable replacement:
1. You need to pull the rubber boot off the gear shift and expose the area where the gear shift cable is connected to the transmission. You will need a repairing kit to do the job. Almost all car manufacturer often offer such kit of necessary tools with the car.
2. What do you see now? You will see the connection of the shift cable and nut through a single nut and bolt.
3. Now remove the gear shift and loosen the nut that holds shift arm and shift cable.
4. Find the sleeve now and slide it off. Then find the other end of the shift cable. Loosen it up from that end as well.
5. Now hitch the new gear shift cable at both anchor points and tighten it up with the nuts and bolts.
6. Fix the gear shift back into the place along with the rubber boot. That’s it!
7. You can now test if it’s functional or not and that you know how to check it.
Author’s Bio: The author is an avid writer. The article explains the easy steps to fix the broken gear shift cable problem.