To put the transmission into the proper gear, which is indicated by the shift selector, a shift selector cable is incorporated into the vehicle. Vehicles with automatic transmission normally have a single cable that runs from the transmission to the shifter assembly, while the manual transmission vehicles have two. If you are looking for shift cable replacement cost in Lakeland and other cities in Florida, you need not worry about the transmission type. This is because both of them display similar traits and signs when they start to go bad. If you are interested to replace your broken shift cable all by yourself, here is a sequence of steps that you can employ for your vehicle.
Step 1- Disconnect the cable from the step
It is relatively easy to fix broken shift cables on a vehicle. At the very beginning, check for the rubber boot that covers the base of the shifter. You will see the shift cable connecting to the base of shifting arm. A nut should be present holding the end in place, and an anchor mounting close to the place, which locks the sleeve from moving. On some vehicle models, you may have the functionality to remove the center console to reach the mechanics, but make sure you know the correct method to pull it off, so it can be reattached once you are done. The next step is to remove the securing nut, and then sliding the sleeve out of the anchor. This might require you to move the shifter a bit to make them loose.
Step 2- Disconnect the cable from the engines control arm
Inside the engine compartment, on one its side you can see the shift cables that connect to the engine shifting arm. Remove the nuts that holds this cable into place and slide the cable sleeve out of the anchoring in similar fashion as you did for the shifter. The damage should most probably be in the cable and not the broken anchor arm. If it the anchor that is broken, this is the actual problem and not the cable itself. In case the anchor gets snapped, bent or broken, you may have to weld a new one to replace it.
Step 3- Connect the new cable
Once you have the information that the two anchoring points are good and the shifter cable replacement is properly done, reverse the process and reconnect the new cable into the vehicle. Starting with the shifter, slide the sleeve into place along the anchor line. Then move the shifter into place so that it fits back over the bolt on the shifter. After this, re-secure the nut to lock it into place. The next steps involves replacing the shifter boot and moving to the engine compartment to finish the job. Lastly, connect the sleeve of the shift cables on the anchor located near the engine, and then bolt it into position on the shifting arm.
Step 4- Check for functionality
Test your shift cables by applying different gear settings, make sure that the cable is hitting the gears correctly before taking out your car for a spin.
Author: The author is a blogger and the article is about shift cable replacement.